The Drift Silicone Rubber Watch Strap

A soft strap for everyday wear

The Drift is a watch strap made of silicone rubber. The material is flexible and smooth against the skin, which makes it a good fit for long days at a desk, trips to the gym, and everything between. It has a clean, unbroken look that keeps the focus on your watch. A silver-tone pin buckle closes the strap, and the tail tucks into a keeper loop so it stays flat on the wrist.

Silicone rubber handles sweat and splashes well. When the strap needs a refresh, a quick wipe with a damp cloth is enough. There is no special cleaner to buy and no long routine to follow.

Pick your lug width

Lug width is the distance between the two lugs on your watch case, where the strap attaches. Measure that gap in millimeters before you order. The Drift comes in two widths.

If your watch measures 20 mm between the lugs, choose 20 mm. If it measures 22 mm, choose 22 mm. A strap that matches the lug width sits flush against the case and wears comfortably. If you are between sizes or unsure, measure twice with a ruler or a caliper before ordering.

Twelve colors to choose from

Color is the easy part. The Drift comes in Black, Navy blue, Pink, White, Wine red, Lavender, Dark green, Orange, Starlight, Light gray, Red, and Dark gray. Black, navy blue, and dark gray are quiet picks that pair with almost any watch. White, starlight, and light gray keep things bright. Pink, lavender, wine red, red, orange, and dark green add a clear pop of color to a casual outfit.

All twelve colors use the same silicone rubber build and the same silver-tone pin buckle. The strap is unisex, so it works on a range of wrist sizes and styles.

Fitting and swapping the strap

Quick release spring bars are included with the strap. These bars have small levers at each end. To install the strap, slide one end of the bar into a lug hole, then pull the lever back and ease the other end into the opposite lug hole. Let the lever snap into place, then tug the strap gently to confirm it is seated.

To remove the strap, pull both levers back at the same time and lift the strap away from the case. No spring bar tool is needed for this step, which makes it simple to change colors for a workout, a trip, or a night out. Keep a spare set of spring bars in a drawer in case one wears out over time.

Once the strap is on, close the pin buckle and slide the tail through the keeper loop. A snug fit keeps the watch from sliding around on the wrist. You should be able to fit one finger under the closed strap.

Care and daily use

Silicone rubber is low maintenance. Wipe the strap clean with a damp cloth or a mild soap and water mix, then dry it with a soft cloth. This removes sweat, sunscreen, and everyday grime. Avoid harsh chemicals, solvents, and sharp tools, which can dull or scratch the surface.

Rinse the strap after heavy sweating or a day at the beach. If you swim often, check the spring bars now and then and replace them if they look worn. With basic care, the strap stays soft and comfortable for a long time.