The Mesh Loop

What it is

The Mesh Loop is a watch band made from woven stainless steel mesh. The fine weave gives it a smooth, low profile feel on the wrist, and the mesh flexes so it sits close without pinching. It closes with a brushed steel magnetic clasp. Slide the clasp to set your length, and the magnet holds it there. No holes, no tools, no sizing links to remove.

This is a band for everyday wear. It suits dive watches, field watches, dress watches and smartwatches with standard lug pins. If you like the look of a fine mesh bracelet but want a clasp you can adjust in a second, this is the one.

Sizes

Lug width is the distance between the two lugs on your watch case, measured in millimeters. Match that number to the band. The Mesh Loop comes in five widths.

Each band has two strap sections: 90 mm (3.54 in) and 110 mm (4.33 in). Together they cover a wide range of wrist sizes, and the magnetic clasp lets you fine tune the fit along the mesh.

Measure your watch before you order. Use a ruler or caliper between the lugs, and check the spring bar width too. If your measurement falls between two sizes, go with the smaller one only if the lugs are truly narrower. A band that is too wide will not seat.

Colors and finishes

Four colors are available:

• Silver: a clean steel tone that matches most stainless cases
• Black: a dark finish that reads sporty and pairs well with black dials
• Gold: a warm tone for gold cases and two-tone watches
• Rose gold: a softer warm tone for rose gold cases and accents

All four use the same stainless steel mesh and the same brushed steel magnetic clasp. Pick the color that matches your case, or pick a contrast color if you want the band to stand out.

Fitting and use

Spring bars are included, and the band has quick release pins. That means you can install it without a spring bar tool. Here is the process:

1. Slide the quick release pin back on one side of the band.
2. Seat that end into the lug.
3. Slide the pin back on the other side and seat it into the opposite lug.
4. Give the band a gentle tug to confirm both ends are locked in.
5. Open the magnetic clasp, wrap the band around your wrist, and close it.
6. Slide the clasp along the mesh until the fit feels right.

The clasp holds by magnet, so set it where the band sits snug but not tight. You should be able to slide one finger under the band. If the clasp slides during the day, move it a few links tighter.

To remove the band, slide both quick release pins back and lift it away from the case. Keep the spring bars in a small bag or box so you do not lose them.

Care

Wipe the mesh and the clasp with a soft dry cloth. Keep the band away from water. Do not wear it in the shower, pool or ocean, and do not soak it to clean it. If the mesh picks up skin oils, a light wipe is enough. Store the band flat or loosely coiled in a watch box or pouch when it is not on your watch.

Mesh can collect dust between the links over time. A dry soft brush, used gently along the weave, helps clear it. Avoid harsh cleaners, polishes and abrasive pads, which can dull the finish.