The Bench Screwdriver Ten-Pack

What it is

The Bench Screwdriver Ten-Pack is a set of ten screwdrivers made of steel. Each tool has a steel shaft and a handle for turning small fasteners. The set comes as a single version with ten screwdrivers.

This is a bench tool. Keep it in a drawer or a watch box, and reach for it when you work on a watch.

What is in the pack

There is one version of this set. You get ten screwdrivers, all in steel. No other tools, tips or cases are included.

How to use it

Work on a clean, flat surface with good light. A tray or a small dish keeps loose screws from rolling away.

1. Match the screwdriver tip to the screw head. A tip that is too small can slip and mark the metal.
2. Seat the tip fully in the slot before you turn.
3. Hold the watch steady with your free hand and turn with light, even pressure.
4. Go slow. Small screws strip easily when you rush.
5. Set each screw aside in your tray as it comes out.
6. When you refit a screw, turn it in by hand until it seats, then snug it down. Do not over-tighten.

Care

Wipe each screwdriver clean after use. A dry cloth is enough for everyday dust and skin oil. Keep the set away from water, and do not soak it or leave it in a damp spot. Store the tools in a dry place, such as a drawer or a watch box, so the tips stay sharp and free of rust.

Why steel matters here

Steel gives the shafts the stiffness you want for small fasteners. A stiff shaft transfers your turn to the screw instead of flexing, which helps you keep the tip seated. Steel also holds up to repeated use, so the set stays with you through watch work.

A note on fit

Watch screws come in different head sizes. Ten screwdrivers give you a range to work with, so you can find a tip that seats well before you turn. If a tip feels loose in the slot, try another size. The right fit protects both the screw and the tool.