The Quick Release Spring Bar Pack

What this pack is

The Quick Release Spring Bar Pack gives you 20 stainless steel spring bars made for watch straps with a 20 mm lug width. Each bar carries a small integrated lever at the end. Pull the lever with a fingernail, and the bar compresses. That lets you remove or install a strap by hand, with no spring bar tool needed.

The bars come in silver and in two diameters: 0.06 in (1.5 mm) and 0.07 in (1.8 mm). Both are common on dive-style and everyday watch cases. The 0.06 in (1.5 mm) size suits slimmer lugs and lighter straps. The 0.07 in (1.8 mm) size fills thicker lug holes and pairs well with heavier bracelets and leather bands.

Quick release bars are a practical upgrade for anyone who changes straps often. Keep a set in your watch box, and you can move a band from one watch to another in seconds.

Sizes and options

All bars in this pack fit a 20 mm lug width. Pick the diameter that matches your watch case and strap.

Measure your strap at the point where it meets the watch case. If that width is 20 mm, these bars are the right fit. Then check the lug holes on your watch. A 0.06 in (1.5 mm) bar slides into a narrow hole. A 0.07 in (1.8 mm) bar needs a slightly wider hole. When in doubt, the thinner bar is the safer choice for a first try.

How to fit and use them

Fitting a quick release bar takes a minute.

1. Set the watch face down on a soft cloth.
2. Hook one end of the bar into a lug hole.
3. Pull the lever back and guide the other end into the opposite lug hole.
4. Release the lever. It should click into place.
5. Tug the strap gently to confirm the bar is seated on both sides.

To remove a strap, pull the lever again and lift the bar free. Repeat on the other side.

A few notes from daily use. Keep the lever facing the back of the watch so it does not catch on sleeves. If a bar feels loose, check that both ends sit fully inside the lug holes. If a bar will not compress, the diameter may be too large for that case, so try the thinner size. Quick release bars are meant for strap changes, not for heavy pulling, so avoid using the lever as a handle.

Care and storage

Stainless steel holds up well to daily wear. Wipe the bars with a dry cloth after contact with sweat, sunscreen or salt water. A soft brush removes dust from the lever area. A small drop of light oil on the lever once or twice a year keeps it moving freely.

Store spare bars in a small box or a divided tray so the levers stay protected. Keep them away from loose tools that could bend the thin ends. With basic care, a set like this lasts through many strap changes.

Why keep a set on hand

Spring bars are small parts that wear out or go missing at the worst time. A 20 piece pack covers two watches with spares left over, or several straps you rotate through the week. If you also keep a watch link removal tool and a watch repair kit at home, this set rounds out the basics for band swaps and light maintenance.

Before you order, confirm two numbers: your strap width at the lugs, which should be 20 mm, and your preferred bar diameter, 0.06 in (1.5 mm) or 0.07 in (1.8 mm). That is all it takes to get the right fit.